This product is easy to use right from an aerosol can. This product comes out of the can as a black rubberized liquid. Rubber In a Can from Alvin Products flows into cracks and holes and creates a tight rubber surface drying to a flexible, rubberized watertight coating. Alvin's rubber in a can should be in every garage, tool box and on the job site.
- Stays flexible
- Seals water and moisture penetration
- Non sagging formulation
- Will not crack, chip or peel
- Application to wet and dry surfaces
- Paintable
Used on Pipes, Gutters, drip pans, roofs, down spouts, campers and RV's, skylights, leaky surfaces, duct work and a/c units, boats, outdoor fountains, birdbaths, ponds and planters, concrete foundations or any surface you need a water tight rubber sealant.
Alvin Products recommends testing each application for suitability. Shake well! Spray on a clean surface holding can 12-15 inches from the surface and apply using steady even strokes. Apply multiple thin coats instead of a single thick coat to ensure dry time and adhesion.
