Alvin Products Metallic Black High Heat Automotive Engine Bruch or Spray Paint
1 Quart Can
High Heat Automotive Spray Paint
Heat Resistant Spray Paint for Auto Parts
WON’T BLISTER, PEEL, BLEACH OR DISCOLOR. WITHSTANDS TEMPERATURES TO 1200°F (649°C)
Premium high heat automotive spray paint withstands temperatures up to 1200°F. High heat spray paint is mainly used on exterior surfaces that are exposed to constant heat above 500°. High heat paint is also called high temperature paint or heat resistant paint.
Benefits of using Alvin Products High Temperature Spray Paint:
- Covers quickly
- Dries in minutes
- Can be recoated as soon as it is dry
Typical Uses for High Heat Paint include:
- Auto engines (high heat engine paint)
- Automotive transmissions
- Diesel exhaust systems
- Steam pipes
- Trash burners
- Wood stoves
- Barbeque grills
To ensure optimum long term coating system performance, surfaces must be clean, dry and free from dirt, oil grease, salts, welding flux, oxides, old paint or other foreign matter.
Prepare surface by power washing, vapor degreasing, solvent cleaning or other chemical and mechanical methods.
Surface cleaning methods recommended will depend upon type of foreign matter to be removed and condition of substrate. Consult Dampney Technical Service for specific recommendations.
Shake can vigorously for one minute until mixing ball begins to rattle.
Hold can no closer than 10-12 inches from surface to be sprayed.
Apply two light coats, allowing 10 minutes drying time between coats. Clean spray head immediately after use by turning can upside down and spraying until no more paint appears. If clogging occurs, remove spray head and clean with a fine wire. Replace carefully, pointing can and spray head opening away from you.
The number of coats of Thurmalox 270 series coatings needed depends upon service conditions of equipment.
Alvin series coatings will air dry tack and thumb print free in 15 minutes and will dry hard in 8 to 12 hours. Allow 1 hour minimum dry time between coats at 70°F (21°C) and 1/2 hour minimum dry time between coats at 90°F (32°C). Coating has excellent recoat properties. Heat curing will provide optimum film properties. Provide ventilation when firing unit for the first time after painting.
Clean up tools with acetone, MEK or toluene.
Store in cool, dry place with temperature between 50°F and 100°F (10°C and 38°C).
WARNING: Flammable Liquid and Vapor Keep away from heat, sparks and flame. Vapors may cause flash fire. Do not breathe vapors or spray mist. Avoid contact with eyes, skin and clothing. Use with adequate ventilation during mixing and application. Observe all safety precautions and follow procedures described in OSHA regulations. Do not paint on hot surfaces.